Edmonton Power Centre

Edmonton Power Center Switchgear structures are ideally suited to applications calling for service entrance, substation and main or sub feeder distribution. 600 Volt - 4000 Amp to 100KA bus bracing. Our Switchgear is manufactured to rugged North American and European standards ( CSA/UL, ANSI, IEC ) and suited for all end uses such as: Industrial, Commercial and Utility.

This Switchgear is designed for:

• Ease of service and maintenance.
• Lower maintenance cost.
• Higher interrupting ratings.
• Better coordination capability.
• Increased tripping sensitivity.
• Better metering accuracy.
• Higher quality and reliability.
• State of the Art monitoring and communications

Manufactures Low Voltage Switchgear 4000 Amp - 600 Volt Main Breaker Section c/w Two Four High Cells and Terminating Cubicle.


Manufactures Low Voltage Switchgear c/w Integral Protection and Control Relaying with PLC Interface Cell.


Low Voltage Switchgear designed with Generator Protection Section and Mechanically Interlocked Breakers for a Standby and Power Transfer scheme.


Combination Low Voltage Switchgear and MCC manually operated and interlocked Main, Tie and Subfeeder Breakers. Extra cooling fans for severe ambient conditions.